Monday, April 19, 2010
Laser Issues
As some of you may know I had a hell of a time laser cutting parts. There's a few photos of the unsuccessful attempts attached here. These parts were attempted on an Epilog 45w laser. I found that only about 10% of the parts actually were cut through. In the end I managed to get access to a 60w Epilog which allowed me to cut all of the parts out.
1/4" Baltic Birch Plywood with interior glue was used. Eventually it was finished with a light sanding to remove the char marks followed by 6 coats of 100% pure tung oil.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment